This Install Guide is intended to help with the installation of the Agency Power Cold Intercooler Upgrade on the 2018 – 2019 Kia Stinger GT with 3.3L TT V6.
Remove bumper by removing bolts from inside engine bay on each side.
Remove the 2 bolts holding bumper in place to fender liner on each side.
Unbolt and clip splash shield to bumper.
Carefully remove bumper and unclip sensor harnesses that are attached.
Loosen clamp on passenger side and remove tube from intercooler.
Driver side has a clip style connector. Unclip to remove intercooler and tube.
With those loose locate the upper intercooler supports. Remove bolt and nut to allow bracket to be removed. Repeat on driver and passenger side.
With brackets unbolted remove intercooler by pulling up.
With intercooler removed transfer bushings to new intercooler.
Place new Agency Power intercooler into lower bushing and start the rebolting upper bracket in place but leave loose until tubes are re-installed.
Reuse the factory clamp and tighten on tube.
Push driver side in place till clips into place. Tighten upper bushing mounts and re-install bumper.