This guide is to help with the installation of the Agency Power Wastegate on the Can-Am Maverick X3.
- For the VR Tuned 195HP package, we recommend setting the wastegate to 1 FULL turn in from neutral.
- For the VR Tuned Big Injector kit, we recommend setting the wastegate to 2 FULL turns in from neutral.
Estimated install time is 25 min
STEP 1 – Access the wastegate by removing the plastic cover located on the back center of the firewall
Step 2 – Remove the 10mm nuts holding on the stock wastegate.
STEP 3 – Install the new Agency Power Wastegate using the supplied 11mm nuts and locking washers
STEP 4 – When installing the wastegate, you need to check the crack pressure. Stock crack pressure on the Can-Am X3 is roughly 7psi. However with this upgraded wastegate, you can set the crack pressure higher up to 14psi for better performance.
If you do not have a might vac pump like pictured, simply do 1 full turn from neutral. Neutral is right before the wastegate rod moves in or out.
FINISHED – Congratulation on installing the Agency Power Wastegate for the Can-Am Maverick X3